This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
rick:weedtrimmer [2016/07/18 00:46] dwheele created |
rick:weedtrimmer [2016/07/20 18:55] (current) dwheele |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| Need to research to see if it is cost-effective to replace the carburetor, or the engine, or maybe the whole device. | Need to research to see if it is cost-effective to replace the carburetor, or the engine, or maybe the whole device. | ||
| + | |||
| + | (Didn' | ||
| {{: | {{: | ||
| {{: | {{: | ||
| + | |||
| + | ^Engine Model|Model #143985012| | ||
| + | |||
| + | Sears Diagram showing engine: | ||
| + | |||
| + | http:// | ||
| + | |||
| + | Ebay has aftermarket for about $13 | ||
| + | |||
| + | A new Craftsman High Wheel 22-inch trimmer is about $399. | ||
| + | |||
| + | Ordered carburetor, spark plug and air filter on ebay for about $30 including same day shipping. 7/17/2016 | ||
| + | |||
| + | Installed carburetor, engine ran for about 2 minutes OK, then started pulsing. Not sure if gas is bad, or if the governor is not running correctly. Will check sparkplug. 7/19/2016 | ||
| + | |||
| + | Read on line that the governor needs to be adjusted. So leaned arm clockwise - Pulsing stopped but runs at lower RPM. Rick said the pulsing is normal. 7/19/2016 6:49 p.m. | ||
| + | |||
| + | Adjusted the arm to be a bit counter-clockwise, | ||
| + | |||
| + | Ordered replacement pull start from Amazon, ETA 7/22. 7/20/2016 11:55 a.m. | ||
| + | |||