projects:a4work:reartrimindicators
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
projects:a4work:reartrimindicators [2019/01/04 03:59] dwheele created |
projects:a4work:reartrimindicators [2019/01/04 05:08] (current) dwheele [Problem] |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| As a test, we disconnected the front seat's meters and connected them to the rear seat wire, and the indications were accurate, so the wiring is deemed correct. | As a test, we disconnected the front seat's meters and connected them to the rear seat wire, and the indications were accurate, so the wiring is deemed correct. | ||
| + | {{: | ||
| + | |||
| + | {{: | ||
| ===== Result ===== | ===== Result ===== | ||
| Line 27: | Line 30: | ||
| It is likely that the internal light bulbs are working. I measured 70 ohms between pins 1 and 4 for the rudder meter, and 80 ohms for the elevator meter. There is another complaint that the rear seat console lighting is not working, so this may be the cause that lighting is not working in these meters. | It is likely that the internal light bulbs are working. I measured 70 ohms between pins 1 and 4 for the rudder meter, and 80 ohms for the elevator meter. There is another complaint that the rear seat console lighting is not working, so this may be the cause that lighting is not working in these meters. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | Measuring between 3 to 5, 3 to 6 and 5 to 6 all were about 430 ohms. Pin 2 is open. I think Pin 1 gets grounded. Pin 4 is to light the gauge. | ||
| + | |||
| + | 1/3/2019 | ||
projects/a4work/reartrimindicators.1546574386.txt.gz · Last modified: 2019/01/04 03:59 by dwheele
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
