projects:a4sim:hardware:steppers:28byj48steppermotor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
projects:a4sim:hardware:steppers:28byj48steppermotor [2021/02/13 00:07] dwheele [How to use 28-BYJ48 Stepper Motor] |
projects:a4sim:hardware:steppers:28byj48steppermotor [2021/02/13 07:43] (current) dwheele [Stepper Motor - 28BYJ-48] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| 28BYJ-48 Stepper Motor. | 28BYJ-48 Stepper Motor. | ||
| + | |||
| + | Might be able to use it by rearranging the gearing. As it is, this unit has high torque, but maybe only 30 rpm - inadequate for the Altimeter hand. | ||
| + | |||
| + | 3D Printing makes it possible to bracket and tap the motion from the gearing. By connecting to a 2nd gear (instead of 4th), it appears to be a 1:28 reduction, instead of 1:64. | ||
| + | |||
| ^Volts|5 Volts| | ^Volts|5 Volts| | ||
projects/a4sim/hardware/steppers/28byj48steppermotor.1613174853.txt.gz · Last modified: 2021/02/13 00:07 by dwheele
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
