Differences

This shows you the differences between two versions of the page.

--- projects:a4sim:componentinventory:rectilinearpotentiometer [2019/10/19 15:29]
admin
+++ projects:a4sim:componentinventory:rectilinearpotentiometer [2020/02/22 17:07] (current)
admin ↷ Links adapted because of a move operation
@@ Line 5: / Line 5: @@
 To detect the position, each has a "Rectilinear Potentiometer." This is a linear sliding potentiometer with 6 electrical connections instead of the usual 3.
-{{:projects:a4sim:componentinventory:20191019_061816.jpg?200 |}}
+{{a4sim:componentinventory:20191019_061816.jpg?200 |}}
-{{:projects:a4sim:componentinventory:rectilinearpot2.jpg?200 |}}
+{{a4sim:componentinventory:rectilinearpot2.jpg?200 |}}
-{{:projects:a4sim:componentinventory:20191019_061753.jpg?600 |}}
+{{a4sim:componentinventory:20191019_061753.jpg?600|}}
+Disassembled to make sure wiper was connecting well. Looks good inside, lightly lubricated. Measured resistance between connection pins. With the exception of the "S" connection, which connects to a metal strip which is ridden by the wiper, the connections just connect to a continuous resistive strip. I don't need it for this application, but the rudder for example, could use the CT as the center.
 ^Terminal^From - (Minus) Ohms^
@@ Line 19: / Line 21: @@
 The "S" terminal must be "Slider" which is connected to the Wiper.
-The normal connections to use with Arduina DAC would be:
+The normal connections to use with Arduino DAC would be:
 ^-|Ground|
 ^S|DAC Input|

Dan's Wiki