projects:a4sim:altimeter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
projects:a4sim:altimeter [2021/03/11 01:12] dwheele |
projects:a4sim:altimeter [2021/03/11 01:58] (current) dwheele [Nano Pinouts] |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| ^Pin^Known As^What is connected to it^ | ^Pin^Known As^What is connected to it^ | ||
| ^6|D3|Rotary Encoder red (input)| | ^6|D3|Rotary Encoder red (input)| | ||
| - | ^9|D6|SDA OLED 1, SDA OLED 2| | + | ^9|D6|I2C Out, SDA OLED 1, SDA OLED 2| |
| - | ^10|D7|SDC OLED 1, SDC OLED 2| | + | ^10|D7|I2C Out, SDC OLED 1, SDC OLED 2| |
| ^21|A2|Rotary Encoder green (input)| | ^21|A2|Rotary Encoder green (input)| | ||
| ^22|A3|Rotary Encoder blue (input)| | ^22|A3|Rotary Encoder blue (input)| | ||
| - | ^23|A4|I2C In, SDC, pulled high with 1K resistor | | + | ^23|A4|I2C In, SDA, pulled high with 1K resistor | |
| ^24|A5|I2C In, SCL, pulled high with 1K resistor| | ^24|A5|I2C In, SCL, pulled high with 1K resistor| | ||
| ^29|Ground|Ground| | ^29|Ground|Ground| | ||
| Line 46: | Line 46: | ||
| ^Pin^Known As^What it is connected to^ | ^Pin^Known As^What it is connected to^ | ||
| - | ^Red|N.O. Switch Pin 1|Arduino Nano D3| | + | ^6|Arduino D3|Rotary Encoder |
| - | ^Black|N.O. Switch Pin 2|Ground| | + | ^4|Arduino Gnd|Rotary Encoder |
| - | ^Green|Channel A|Arduino | + | ^21|Arduino A2|Rotary Encoder Channel A (Green)| |
| - | ^Yellow|Common|Ground| | + | ^4|Arduino Gnd|Rotary Encoder |
| - | ^Blue|Channel B|Arduino | + | ^22|Arduino A3|Rotary Encoder Channel B (Blue)| |
| ===== Using 28BYJ-48 Stepper Motor to drive the hand ===== | ===== Using 28BYJ-48 Stepper Motor to drive the hand ===== | ||
projects/a4sim/altimeter.1615425129.txt.gz · Last modified: 2021/03/11 01:12 by dwheele
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
