projects:3dprinting:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
projects:3dprinting:start [2021/09/05 00:09] dwheele [Leveling the Bed] |
projects:3dprinting:start [2023/07/12 04:49] (current) dwheele [Leveling the Bed] |
||
|---|---|---|---|
| Line 38: | Line 38: | ||
| This has been working fine. I adjusted the bed today 5/18/2021 to print something which fills the bed, and the corners were off. | This has been working fine. I adjusted the bed today 5/18/2021 to print something which fills the bed, and the corners were off. | ||
| + | |||
| + | ===== Plastic Won't Stick to the Bed ===== | ||
| + | |||
| + | Had problem where the filament came out a bit whispy, and it wouldn' | ||
| + | |||
| + | Used new needles to clean out the nozzle. The new needles are a bit larger in diameter (although shorter), and fit tighter in the nozzle orifice, perhaps cleaning it out better. 7/11/2023 | ||
| + | |||
projects/3dprinting/start.1630800578.txt.gz · Last modified: 2021/09/05 00:09 by dwheele
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
