Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:start [2021/05/18 18:04]
dwheele [GCODE Format]
+++ projects:3dprinting:start [2023/07/12 04:49] (current)
dwheele [Leveling the Bed]
@@ Line 29: / Line 29: @@
   * https://www.youtube.com/watch?v=mfVTD8d-a4o
+  * This has a file at https://www.thingiverse.com/thing:4803058
+Files: LevelBed_NRML_GCODE_file.gcode, LevelBed_CNTR_GCODE_file.gcode
 The idea is that if you Disable Steppers, the print head can move vertically while trying to move it around, causing it to become out of adjustment.
@@ Line 35: / Line 38: @@
 This has been working fine. I adjusted the bed today 5/18/2021 to print something which fills the bed, and the corners were off.
+===== Plastic Won't Stick to the Bed =====
+Had problem where the filament came out a bit whispy, and it wouldn't stick to the bed. Tried doing a LevelBed_CNTR_GCODE process moving the nozzle closer to the glass without improvement.
+Used new needles to clean out the nozzle. The new needles are a bit larger in diameter (although shorter), and fit tighter in the nozzle orifice, perhaps cleaning it out better. 7/11/2023

Dan's Wiki