pc:software:freecad:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
pc:software:freecad:start [2021/01/01 17:57] dwheele [Draft] |
pc:software:freecad:start [2021/01/01 20:49] (current) dwheele [Draft] |
||
|---|---|---|---|
| Line 35: | Line 35: | ||
| **Snaps (in Draft Workbench)** | **Snaps (in Draft Workbench)** | ||
| + | |||
| + | Use some of the Snap tools. (Green icons.) | ||
| + | |||
| + | **Modify (not just change Draft Workbench items, can change anything)** | ||
| + | |||
| + | Blue icons in the Draft Workbench. | ||
| + | * Rotate | ||
| + | * Move | ||
| + | * (others) | ||
| + | |||
| + | Read in the Wiki to see how to use the tools. | ||
| + | |||
| + | **Plane Control** | ||
| + | |||
| + | Allows you to draw at an offset from the main coordinate system. Can use to draw on different floors of a house, for example. | ||
| + | |||
| + | |||
| + | |||
pc/software/freecad/start.1609523847.txt.gz · Last modified: 2021/01/01 17:57 by dwheele
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
