Differences

This shows you the differences between two versions of the page.

--- pc:hardware:thrustmasterboeingyoke [2024/01/03 19:30]
dwheele [Malfunction - X-Axis not centered, eratic]
+++ pc:hardware:thrustmasterboeingyoke [2024/07/12 23:47] (current)
dwheele
@@ Line 10: / Line 10: @@
 {{:pc:hardware:thrustmasterhalleffectcircuitboardfront.jpg|Hall Effect Sensor in Center}}
-Guessing E1 is Zener Diode. Left connector is wired to circuit board in yoke, connecting to triggers, thumbsticks, etc. The X-Axis started working again for a while when I connected oscilloscope probe to right-most connection. Maybe Zener Diode has connection problem?
+Guessing E1 is Zener Diode. Left connector is wired to circuit board in yoke, connecting to triggers, thumbsticks, etc. The X-Axis started working again for a while when I connected oscilloscope probe to right-most connection (which goes to pin 3 of the Hall Effect Sensor - Output). Maybe Zener Diode has connection problem?
 {{:pc:hardware:thrustmasterhalleffectcircuitboardback.jpg|Hall Effect Sensor Back}}
+Apparently some of the wiring became broken. The wire which plugs in near E1 was pulled loose, so straightening it seemed to help.
+The thumb joy stick which changes the view horizontally also started being erratic. Apparently fixed by soldering a red wire along that ribbon cable's red edge wire. The wire seemed to have a limp place. Pushing on the wire just slightly caused the joy stick output to fix, at least temporarily.
+The wire is
+position (individual wires) in a ribbon cable, 6" long, 0.8mm pitch
+^Part|08SUR08SUR32W150|
+JST

Dan's Wiki

User Tools

Site Tools

Differences

Page Tools